厂房环氧地坪一般要求防滑,耐磨,抗压且易清理特点,因此选择环氧树脂地坪是最合适的。根据厂房地面情况选择合适的施工工艺。环氧薄涂环氧地坪,环氧砂浆环氧地坪,环氧自流平地坪等。地面情况较差,一般选择2.0mm环氧砂浆地坪或者3.0mm环氧砂浆地坪;选择环氧自流平也可行,只是造价微高,但做出来的效果美观,抗压性和耐磨损性是最佳的,且使用年限长久。地面情况较好,新地面,一般较简单的工艺是薄涂地坪和砂浆地坪,由于经常走叉车地牛,建议在面涂施工后涂刷罩光清漆,这样就能抗划伤,不易损坏地坪漆。
The epoxy floor of factory building generally requires anti-skid, wear-resistant, compressive and easy cleaning characteristics, so the epoxy floor is the most suitable choice. The suitable construction technology is selected according to the ground condition of the workshop. Epoxy thin coated floor, epoxy mortar floor, epoxy self-leveling floor, etc. Ground condition is poor, generally choose 2.0 mm epoxy mortar floor or 3.0 mm epoxy mortar floor; choose epoxy self-leveling is also feasible, but the cost is slightly high, but the effect is beautiful, compressive and wear resistance is the best, and the service life is long. The ground condition is better, the new ground, generally the simpler process is thin coated floor and mortar floor. Because forklift cattle are often used, it is recommended to apply varnish after surface painting, so as to resist scratches and not easy to damage the floor paint.
环氧地坪漆涂刷做法:
Brushing method of epoxy floor paint:
①地面打磨清理干净;
The ground is polished and cleaned.
②涂刷高效环氧底漆一道,涂料要足,完全封底;
(2) Paint a high-efficiency epoxy primer, the paint should be sufficient, completely sealed;
③刮涂无溶剂中涂层砂浆,(这道工序也可以不用,如果使用会增强地坪的硬度和使用年限)
(3) Scraping solventless coated mortar, (this process can also not be used, if used will enhance the hardness of the floor and service life)
④刮涂环氧腻子两道;
Fourthly, scrape and coat epoxy putty in two ways.
⑤涂刷两遍环氧面漆。
(5) Brush the epoxy finish twice.
⑥涂刷罩光清漆(这道工序可选)
_Brushing varnish (this process is optional) 本站网址:http://www.wuxispeed.com
|