大家应该都知道，产品大大低于本身的价格，那么其中肯定是有原因的，也就如同在选用劣质产品和价格低廉环氧地坪漆的时候，相应的就会出现很多一系列问题。使用劣质环氧地坪漆涂装的所带来危害有哪些呢?环氧地坪漆涂料储存时间太长、温度过高、受到紫外光照射等导致涂料已开始预固化而产生凝胶体小颗粒，导致涂料已开始预固化而产生凝胶体小颗粒。除尘不当，小刨花、锯末、灰尘等杂质污染涂膜。因此，光固化环氧地坪涂料应储存在通风阴暗处，如在高温、强紫外线的地方存储，一般不宜超过三个月。做好涂装车间、生产线和木板面的除尘工作，保持环氧地坪漆涂装线周围的环境清洁。

You should all know that the product is much lower than its own price, then there must be a reason, just as in the selection of inferior products and inexpensive epoxy floor paint, there will be a series of corresponding problems. What are the hazards of using inferior epoxy floor coatings? The storage time of epoxy floor coatings is too long, the temperature is too high, and the coatings are irradiated by ultraviolet light, which leads to the pre-curing of the coatings and the formation of gel particles, which leads to the pre-curing of the coatings and the formation of gel particles. Improper dust removal, small shavings, sawdust, dust and other impurities contaminated the film. Therefore, UV-curable floor coatings should be stored in dark and ventilated places, such as high temperature, strong ultraviolet radiation, generally not more than three months. Do a good job of dust removal in painting workshop, production line and wood surface, and keep the environment around the floor painting line clean. 低档位的环氧地坪漆在施工中还会遇到发酵、凹坑等情况，出现此类情况的原因大致有下面三点。涂料自身的相容性差。地坪漆涂料内混入了不相容的物质，如油、水、表面活性剂等。被涂木板表面除尘不干净或被油、蜡质、表面活性剂等污染。

Low-grade epoxy floor paint in the construction will also encounter fermentation, pits and other situations, the reasons for this situation are roughly the following three points. The compatibility of paint itself is poor. Incompatible substances, such as oil, water and surfactant, are mixed into the floor paint. The surface of the coated wood board is not clean or polluted by oil, wax, surfactant, etc.

环氧地坪漆品牌团队通常会选用优良、相容性好的光固化涂料品种。严格防止油、水、表面活性剂等物质混入涂料内。对被涂木板表面的灰尘要清除干净，避免蜡质等对其表面的污染。

Epoxy flooring paint brand team usually choose a variety of light curing coatings with good compatibility. Strict prevention of oil, water, surfactant and other substances into the paint. The dust on the surface of the coated wood board should be cleaned up to avoid wax contamination on its surface.