在环氧地坪漆施工前要先进行地面的清洁和油污处理,需要根据油污的污染程度,包括浸蚀年限、油污渗透深度及污染面积等做如下的处理:在我们接触的无锡环氧地坪工程中,旧地面翻新和地面有油起砂的比例占了5/2,这里面“地面有油污”是最麻烦,最难处理的。油污地面如何进行环氧地坪漆施工。 通常在环氧地坪漆施工前,首先要将地面清洗干净,特别是地面有一些油渍或者化学用品一定要清理干净,否则这些油污会严重影响环氧地坪施工的质量,严重的话还会造成地坪漆脱落,起气泡等问题。
Before the construction of epoxy floor paint, the ground cleaning and oil pollution treatment should be carried out. According to the degree of oil pollution, including erosion life, oil penetration depth and pollution area, the following treatment should be done: in the epoxy floor project we contacted, the proportion of old ground renovation and oil sand on the ground accounted for 5/2, where the surface is covered.“ Oil stains on the ground are the most troublesome and difficult to deal with. How to construct epoxy floor paint on oily ground? Usually before the floor paint construction, the first thing is to clean the ground, especially some oil stains or chemicals on the ground must be cleaned up. Otherwise, these oil stains will seriously affect the quality of the floor construction, if serious, it will also cause the floor paint to fall off, bubbles and other issues.
1、薄层油污层(d2mm)可采用铣刨机整体去除;
1. Thin oil contamination layer (d2mm) can be removed by milling machine as a whole.
2、如油污只存在于表面,可采用油污清洗剂或溶剂清洗去除;
2. If oil contamination only exists on the surface, it can be removed by cleaning agent or solvent.
3、厚重油污层:整体去除后重新浇筑混凝土或采用铣刨机整体去除;
3. Thick and heavy oil contamination layer: re-pouring concrete after whole removal or whole removal by milling machine;
4、局部油污可采用火枪烧除。
4. Local oil pollution can be removed by gun.
5、用无水乙醇或二丁酯擦洗表面---脱脂。
5. Scrub the surface with absolute ethanol or dibutyl ester - degrease.
6、用面粉和锯末混合后炒热后铺到表面上,最少一天---吸油。
6. Mix flour and sawdust, stir-fry and spread on the surface for at least one day - oil absorption.
7、用电动工具均匀的在表面钻一定数量的小洞,20毫米即可---形成胶钉。
7. Drill a certain number of small holes evenly on the surface with electric tools, 20 millimetres - - to form a glue nail.
施工的质量不仅是要求施工过程中不能有差错,施工前也要将地面清理干净,这样才能保证地面的质量,在日后的使用过程中,避免不必要的问题出现而影响正常的使用。
The quality of construction not only requires that there should be no errors in the construction process, but also that the ground should be cleaned up before construction, so as to ensure the quality of the ground and avoid unnecessary problems in the future use process and affect the normal use. վַhttp://www.wuxispeed.com
|