环氧地坪漆施工质量的的归纳起来:施工方案、基材、机械、人、环境,其中最主要的两个因素为基材与环境,无锡环氧地坪施工最基础的就是基材,基材的强度与涂料的附着力等都会直接影响施工环氧地坪的使用寿命,所以基材状况成为重要。所谓环氧地坪是指一种高强度、耐磨损、美观的地板,这类特殊工艺的地板具有无接缝,质地坚实,耐药品性佳,防腐,防水,防尘,保养方便,维护费用低廉等优点;优质的环保环氧地坪与其施工工艺与质量有着密切的关系,尤其是环氧地坪表面的处理方式,不仅处理方式的各个环节不能出错,而且处理步骤也不能乱,否则环氧地坪的质量将得不到保障。而在环氧地坪漆施工中,我们常见的基材有混凝土、水泥砂浆、水磨石和钢铁,但施工质量一直是我们所最为重视的,那么到底影响施工质量的因素有哪些呢?
The construction quality of epoxy floor paint can be summarized as follows: construction scheme, base material, machinery, human and environment. The two most important factors are base material and environment. The most basic factor of epoxy floor construction is base material. The strength of base material and the adhesion of coating will directly affect the service life of construction floor, so the condition of base material. Be important. The so-called epoxy floor is a kind of high-strength, wear-resistant and beautiful floor. The floor with this special technology has the advantages of seamless, solid texture, good resistance, anti-corrosion, waterproof, dust-proof, convenient maintenance, low maintenance cost, etc. The high-quality environmental protection floor has a close relationship with its construction technology and quality, especially It is the treatment method of epoxy floor surface, not only every link of the treatment method can not make mistakes, but also the treatment steps can not be disorderly, otherwise the quality of epoxy floor will not be guaranteed. In the construction of epoxy floor paint, the common substrates are concrete, cement mortar, terrazzo and steel, but the construction quality has always been our most important, so what are the factors affecting the construction quality? 1、基层的附着物。在水泥基层表面一般都会有施工中的水泥尘埃,建议在施工前将其清除。
1. Attachments at the grass-roots level. In general, there will be cement dust in construction on the surface of cement base. It is suggested that it be removed before construction.
2、环境条件。环境条件是指对工程质量特性起重要作用的环境因素,它往往对工程质量产生特定的影响,施工环境温度控制在10——35°之间,温度不易过高或过低。空气相对湿度小于75%为宜。
2. Environmental conditions. Environmental conditions refer to the environmental factors that play an important role in the quality characteristics of the project. They often have a specific impact on the quality of the project. The temperature of the construction environment is controlled between 10 and 35 degrees, and the temperature is not too high or too low. It is advisable that the relative humidity of air is less than 75%.
3、基面强度。强度不足容易导致无锡环氧地坪涂层与基材被拉开,或是因为承受不住压力而使地面收到破坏。一般要求基材压缩强度大于25MPa。
3. Base strength. Insufficient strength can easily cause the floor coating and base material to be pulled apart, or the ground to be destroyed because it cannot withstand pressure. It is generally required that the compressive strength of the base material be greater than 25 MPa.
4、基面平整度。基面不平整会影响基材与涂料的附着力,所以事先要对其进行检测,一般使用2m的靠尺,用塞尺测量靠尺下的缝隙,在3mm以下的都属于平整的。
4. Base smoothness. The unevenness of the base surface will affect the adhesion between the base material and the paint, so it should be tested beforehand. Generally, the gap under the ruler is measured by a 2-meter ruler and a plug ruler, which is flat below 3 mm.
5、基层干燥程度。混凝土和砂浆的地面是一定要干燥的,因为如果含有水分会降低涂层与基层的链接强度,也会导致脱层、鼓泡等涂膜弊病。
5. Drying degree of grass-roots. The ground of concrete and mortar must be dry, because if it contains water, it will reduce the linking strength between coating and base layer, and also lead to delamination, bubbling and other film defects. 本站网址:http://www.wuxispeed.com
|